GPS gradually replaces maps as the main tool used by drivers for navigation. However, GPS also has limitations. In order to accurately locate the position of the car and calculate the route, the GPS system needs to continuously receive signals from the satellite network. In the open area, this process will have no problems. In the urban areas with high buildings, most of the satellite signals will be blocked by the building or reflected by the exterior glass. The same situation can occur in sections such as underground tunnels. At these times, the GPS will temporarily lose its effect, and can only wait to leave the current road segment to regain the signal and then connect again. This article refers to the address: http:// To address the limitations of GPS, Swiss semiconductor manufacturer U-Blox has developed a navigation chip. The chip utilizes a new system called 3D Automotive Dead Reckoning (3D ADR). Unlike traditional GPS, which relies solely on satellite signals, 3D ADR uses sensors to track the speed of the vehicle, the direction of horizontal motion, and the elevation angle with the horizontal ground. Among them, the elevation angle data is particularly important, and is mainly used to estimate the trajectory of the vehicle in the multi-level parking garage, which is a blind spot of the traditional GPS system. By measuring the motion of the vehicle in three dimensions, the 3D ADR allows the car navigation system to acquire the position of the vehicle, although not as accurate as real-time navigation, but at least much better than losing the satellite signal. The 3D ADR is a chip that can be easily installed inside the vehicle's built-in sensors and navigation system. U-Blox says the chip is not related to the type of vehicle powertrain and can be used in most vehicles.
P3 Rental Outdoor Full Color Led Display of Rental Series, which widely used in Outdoor Advertising Stage Rental Projects, like Square, Station, Commercial Center, Street etc. Mainly used for outdoor high density picture display. P3 Outdoor Led Display using the distribution and modular design to improve the stability of the LED Display control system. High Brightness to meets needs of outdoor environment, high gray and high refresh, meet the camera to sheet demand. P3 Led Screen with SMD table stick package, to meet the large angle of the viewing of P3 Led Display.
1. High refresh rate 1200Hz ,best scan method for energy saving, perfect 16bits grey level, exclusive technology on driving IC to remove ghost shadow and more pattern, good effect on photographing.
Salty spray test, high voltage test, varying temperature test, waterproof test, vibration test.Long service time and low attenuation by applying dual channels for heat dissipation.High protection grade of IP65 achieved by patented mask design with waterproof and dustproof fuction.
P3 Led Display,P3 Led Screen,P3 Led Screen Panel,P3 Outdoor Led Display Shenzhen Jongsun Electronic Technology Co., Ltd. , https://www.jongsunled.com
2. Thin: It is die-casting aluminum cabinet, thus it is featured by high strength, toughness, precision and it is hard to be deformed. The edge is just 33mm comparing to the 160mm of common cabinet.
3. Fast: There is fast locking device in four corners. It takes only 10 seconds to assemble one cabinet. It is fast and precise assembling.
January 25, 2021